Garage Door Torsion Spring Replacement

On average there are two springs mounted on the garage door. A long and heavy-duty spring that is placed at the upper portion of the garage door is called the torsion spring while the extension springs are mounted at the sides of the garage door.

The springs that are connected to a metal plate which is fixed and mounted above the garage door opening and parallel to the surface of the frame are known as “torsion springs”. These springs function on the basic principle of twisting to generate and release the power to lift and lower the garage door. These springs also have cables that are connected to each side of the garage door on the bottom panel. When you need to replace the broken garage door springs, you cannot replace them because it is an extremely complicated and dangerous task. You will have to hire a garage door specialist to do the job. Visit the website for help and contact them.

It is extremely essential to note here that garage door torsion springs can be dangerous if it is not conducted with the right precautions because the tension stored in the springs can hurt you. Therefore, you should be extremely conscious because you could lose your eyes, hand, fingers, limbs, and even your life. So you must be qualified and skilled enough. This is why garage door springs replacement and adjustment tasks should leave to the expert technician.

  • Before performing the garage door spring replacement task, release the pressure from the old spring
  • Never touch the cable drums and winding cones
  • Don’t wind off or wind up the springs using a screwdriver
  • Always insert a bar at first that is well-fitting into the winding core before touching the setscrews. Never use a box wrench or socket wrench for the set screw.
  • Make sure to keep the bar in the center of the cone while performing garage door spring replacement.
  • While wounding the springs never touch the brackets

The safest procedure to replace the garage door springs is as follow:

  • Disconnect the power cord from the socket. Remove it from the garage door. In the old versions of the garage door, you will have to remove the fuse or flip the circuit breaker.
  • Make sure that you have bought the right part to replace the old spring. You should also check the type, material, and dimensions of the new spring to the old one. Never touch the winding cone and avoid grabbing the springs.
  • Don’t forget to mark each end of the shaft to help to maintain the balance of the garage door after the new spring installation. 
  • Now wind off the spring which is not still broken and then undo and remove the screws and bolts after securing the cones to the brackets.
  • Replace and reinstall the new components
  • confirm that you wind up the replaced spring
  • Check the alignment of the garage door
  • Apply some sort of lubrication to avoid friction
  • Reconnect the garage door opener and see if it works.

Leave a Reply

Your email address will not be published.